Jan 06, · d. Configure a default gateway. To make your switch accessible from a remote network using Telnet or SSH, you’ll need to configure it with a default router. For example, L2 switches would only need a Default Gateway (DG) with L3 capabilities when they need management from external networks. To configure a DG on your Cisco switch.
How to set a default gateway for your Cisco Switch or Router -- CCNA default gateway setting Cisco
Cisco routers can be configure as both DHCP servers and DHCP clients. An interface on a router that connects to the Internet Service Provider (ISP) is often configured as a DHCP client. This way, the ISP can provide the IP information to the client device. To configure an interface as a DHCP client, the ip address dhcp interface mode command is. To configure the default gateway for the switch, use the ip default-gateway command. Enter the IP address of the default gateway. The default gateway is the. However, to perform switch management over the network or use protocols such as SNMP, the switch will need to have an IP address. The IP address is configured under a logical interface, known as the management domain or VLAN. Usually, the default VLAN 1 acts like the switch’s own NIC for connecting into a LAN to send IP packets.
The default gateway IP address is the IP address of the router or device that all non-local network traffic should go through in order to reach its destination. Oct 17, · The question is: "Which command set the default gateway to on a Cisco switch" that's mean an L2 switch otherwise it would say L3 Switch. Anyways, people already answered that question, only ip default-gateway x.x.x.x is the only good answer for setting up a Default Gateway.